For Usb Interface - Epson TM-T88IV Technical Reference Manual

For USB Interface

Connect the printer to a host computer via a USB port.
• A customer display (DM-D series) can be connected to the printer with the USB interface
by the exclusive modular cable (RJ-45). When connecting the customer display, connect
the modular jack from the customer display to the DM connector.
• When connecting a customer display to the printer with the USB interface, set the com-
munication conditions of the customer display as follows:
∗ Baud rate: 19200 bps
∗ Bit length: 8-bit
USB interface connection diagram
Connecting the USB interface cable
1
Attach the locking wire saddle at the location shown in the figure below.
2
Put the USB cable through the locking wire saddle.
Putting the USB cable through the locking wire saddle, as shown in the figure below,
prevents the cable from coming unplugged.
USB upstream connector
3
Connect the USB cable from the host computer to the USB upstream
connector.
∗ Parity: no parity
∗ Stop bit: 1
USB cable
TM-T88IV
Chapter 2 Setup
DM-D
Modular cable
Modular cable
Cash drawer
UB-board
Locking wire saddle
USB cable
2
47