Printing and Cutting Positions
Manual-cutter position
Autocutter blade position
Center of the print dotline
The values above may vary slightly as a result of paper slack or variations in the paper.
Take the notice into account when setting the cutting position of the autocutter.
Paper Specifications
Paper type
Form
Size
Roll paper diameter
Roll paper spool
Take-up roll paper width
Paper width
Specified roll paper type
• Paper must not be pasted to the roll paper spool.
• The remaining amount of the roll paper when a roll paper near-end is detected differs
depending on the spool type.
Approx. 15
Printable area
[units: mm (All the numeric values are typical.)]
Specified thermal paper
Roll paper
83 mm {3.27"} maximum
Inside: 12 mm {0.47"}, Outside: 18 mm {0.71"}
80 + 0.5/-1.0 mm
79.5 ± 0.5 mm
NTP080-80
In U.S.A.: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
(Original paper: TF50KS-E Nippon Paper Industries Co., Ltd.Åj
Chapter 1 Product Overview
Last line of
a previous receipt
Approx. 29
Paper feed direction
25
1