Cockpit Cover - Regal 2100 Owner's Manual

TYPICAL BIMINI TOP W/ BOWS

Cockpit Cover

TYPICAL COCKPIT
COVER
below the windshield. Complete snapping the canvas to the outside
and then down each gunnel to admidships. Your boat may use several
cockpit poles. Their purpose is to keep the canvas tight and water out
of the interior. Notice on the underside of the cover there are areas of
reinforced canvas material. These are for the cockpit cover poles. Each
pole is adjustable by opening it to the desired length and tightening
the thumb screw. You may fi nd it helpful to mark the poles so you
can install the poles in the same spot each time. Continue to snap the
cockpit cover to the deck snaps.
Equipment Operation
The cockpit cover installs over the
windshield and snaps to the deck. To
install the cockpit cover, note that
on the bow end of the cover there
is a middle seam on the inside which
separates the port and starboard sides.
Align this seam with the center snap
6-11