Precor EFX 447 Owner's Manual page 98

3. Secure the back of the bottle holder using two ⁵ ₁₆-inch x ³ ₄-inch hex head
screws and two ⁵ ₁₆-inch washers. Partially tighten the fasteners.
Figure 34: Back bottle holder attachment
4. Secure the bottle holder around the console bracket and attach it using two
#10 Phillips head screws. Fully tighten the fasteners.
Figure 35: Bottle holder placement
Assembling the Equipment
5. Fully tighten the fasteners on the back of the bottle holder.
6. Place the top cover over the console bracket by hooking it in the back and
rotating it forward. Attach it using two #10 Phillips head screws. Fully tighten
the fasteners.
Note: For proper fit, make sure the tabs are lined up on the inside of the top
cover.
Figure 36: Top cover attachment
17