Electrolux EI27BS26JB Service Data Sheet

PERFORMANCE DATA NO LOAD & NO DOOR OPENINGS AT 37°/0° CONTROL SETTING
Type A with Run/Start Capacitor 65°F (18°C) Ambient
Operating Time 90 to 100%
Freezer Temperature -5° to 2° F (-20° to -17° C)
Refrigerator Temperature 34° to 39° F (1° to 4° C)
Low Side Pressure -2 to 6 psig ( -14 to 41 kPa)
High Side Pressure (last 1/3 cycle) 85 to 105 psig (586 to 724 kPa)
Wattage (last 1/3 cycle) 30 to 50
Amps (running) .4 to .8
Base Voltage 115 vac (127 vac max)
DEFROST SPECIFICATIONS
Thermostat
Cabinet Size
Cut-in Cut-out
26' & 28' SD, 23' CD 25° F (-4° C) 47° F (8° C)
Electronic Timer - (ADC) Defrost 24 minutes every 6-96 hours of compressor run time.
CONDENSER FAN MOTOR
Watts RPM
3.1 1100 CW Opposite Shaft
FREEZER ICE MAKER SPECIFICATIONS
Electrical 115 vac (127 vac max)
Thermostat Opens at 48° F ( 9° C), Closes at 15° F ( -9° C)
Heater Voltage 85 vac
OPTIONAL FREEZER ICE MAKER CONNECTOR PLUG
Wire Number Wire Color
1 Green/Yellow
2 Yellow/Blue
3 Black/Orange
4 Light Blue
IMPORTANT SAFETY NOTE
The information provided herein is designed to assist qualified repair personnel only.
Untrained persons should not attempt to make repairs due to the possibility of electrical
shock. Disconnect power cord before servicing this appliance.
IMPORTANT
If any green grounding wires are removed during servicing, they must be returned to
their original position and properly secured.
NOTE
This product comes equipped with an Adaptive Defrost Control (ADC). To activate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A "d" in the freezer temperature window and "F" in the refrigerator
temperature window will display when the heater is activated. To deactivate manual
defrost, simultaneously press and hold the Fresh Food up (+) and Fresh Food down (-)
keys for 5 seconds. A "d" and "F" will be displayed until the defrost cycle is complete.
CAUTION
All electrical parts and wiring must be shielded from torch flame. DO NOT allow
torch to touch insulation; it will char at 200°F and flash ignite (burn) at 500°F.
Excessive heat will distort the plastic liner.
90°F (32°C) Ambient
100%
-1° to 3° F (-18° to -16° C)
ICE & WATER - AUTOMATIC DEFROST
34° to 39° F (1° to 4° C)
-2 to 6 psig (-14 to 41 kPa)
120 to 135 psig (827 to 931 kPa)
Ice Maker Errors Displayed on "UI"
50 to 70
.7 to .9
ERROR
None
Heater
Watts Ohms
500 26.5
Amps
0.03 Running System Error Codes Displayed on "UI"
ERROR
OP or 2
SH or 3
OP or 2
Connects to:
SH or 3
Ground
SY EF
Water Valve
SY CE
Line
Neutral SY CF
To initiate manual defrost press and hold, for 5 sec. FF(+) and FF(-), (d) and (f) will
be displayed.
dF
FREEZER ICE MAKER INFORMATION
Test Cycling:
Remove cover by inserting screwdriver
in notch at bottom and prying cover from housing. Use
screwdriver to rotate motor gear counterclockwise until
holding switch circuit is completed. All components of ice
maker should function to complete the cycle.
Water Fill Volume:
will change the fill time. One full turn is equal to 20cc
(.68 oz.). The correct fill is 102 to 130cc (3.4 to 4.3 oz.).
When a water valve is replaced, the fill volume must be
checked.
SERVICE DATA SHEET
240389646
BOTTOM FREEZER - R134a
Freezer Sensor OPEN
Freezer Sensor SHORTED
FF Sensor OPEN
FF Sensor SHORTED
Evaporator Fan Circuit
Communication error
Communication error
In Manual Defrost (See Note)
Water Fill
Adjustment
Motor
Gear
The water fill adjustment screw
Mounting
Plate
Screw
IMPORTANT
PLEASE RETURN THIS SHEET TO IT'S ORIGINAL LOCATION.
Diagnostic Mode
Test Activate: Hold FF (+) and FZ (+) for 5 sec.
52C Ice tray thermistor temperature displayed - OK, OP open, SH short
55C
Water valve test
57C Fan test, on or off
58C Ice level sensor switch test
63C
Harvest motor system test
De-activate: Hold FF (+) for 5 sec.
Diagnostic Mode
Test Activate: FZ (+) and FZ (-) for 5
sec.
1 Standard compressor
2
Defrost heater
3 FF lighting
8 Water valve,water disp.
9
FZ lighting
10 Auger motor
11 Cube/crush solenoid
41
Perfect Temp Drawer
12 VCC Condensor fan
38 VCC Compressor
15 Evaporator fan
De-activate: Hold FF (+) for 5 sec.
LINE POWER
ICE MAKER
BLK BRN
P-3
THERMAL
CUT-OUT
Mounting
MOTOR
Plate
Screws
HOLD
SWITCH
RED
C
Timing
Gear
MOLD HEATER
165 WATTS
GRN / YEL
P-1
MOLD MOUNTING
PLATE
ICE MAKER
Note: See Service Manual for
complete description.
Note: See Service Manual for
complete description.
22 Damper
23
Fresh food door
24 Freezer door
26 Defrost limit switch
28
Dispenser paddle
36 Ice door
29 FF Thermistor
30
FZ Thermistor
33 Ambient Thermistor
0- Software version
NEUTRAL
RED
YEL
NO
P-2
THERMOSTAT
NC
NO
BLU
BLK
NC
C
SHUT-OFF
NO
SWITCH
NC LT. BLU
C
P-4
WATER FILL
SWITCH