Attaching The Handstrap - Honeywell MX9 User Manual

Attaching the Handstrap

Note: Either the trigger handle is attached to the MX9 or the handstrap is attached, not both. In the absence of a trigger
handle, the handstrap should be used at all times. The handstrap is pre-installed on a MX9 that is purchased without a
trigger handle.
1. Place the MX9 with the screen facing down, on a flat stable surface.
2. Place the handstrap base (2) in the grooved area, matching the screw holes in the handstrap base with the screw holes
in the body of the MX9.
3. Insert the screws (supplied) into each of the four holes and fasten the base securely.
4. Slide the handstrap bottom clip pins into the slots at the base of the MX9 and pull the strap towards the top of the MX9
until the top clip slips into the groove.
5. Making sure the closed loop fastener surface on the handstrap are facing up, slide the strap through the latch in the top
clip.
6. Fold the end of the strap over so that the closed loop fastener surfaces mate evenly and the handstrap is secured to the
MX9.
7. Test the strap's connection making sure the MX9 is securely connected to each end of the strap connectors.
Check the closed loop fastener and handstrap base connection frequently. If loose, they must be tightened or replaced before
the MX9 is placed into service again.
2-20