Roland Metaza MPX-90 User Manual page 95


Impact--MIN
You can set the minimum value of print impact for an image.
Raise the value when dark areas of the image are not struck.
Lower the value when dark areas of the image are whitish or
when overall striking is too forceful.
Impact--MAX
You can set the maximum value of print impact for an image.
Raise the value when bright areas of the image are struck with
too little force or when overall striking is too weak.
Lower the value when bright areas of the image are struck with
too much force.
Vector Impact
You can set the maximum value of print impact for a line.
Materials and Values of Impact (Reference values)*
Material
Brass or Copper
Iron or Stainless steel
Titanium
* The coating of a coated material may come off when the stamping force is too strong. If the coating comes
off, it may cause a malfunction. Adjust the print impact so that the coating will not come off.
Continue on the next page
5-3 Composition Registration and Striking-force Adjustment
OutputResolution
You can specify the number of dots per inch.
Drafting
You can skip image information in increments of one
dot.
Impact--MIN
200
200
200
Chapter 5 Maintenance and Adjustment
Enter a name for the composi-
tion you're registering.
Enter [Speed/Impact]
The printing results vary according to the
hardness of the material. Adjust to match
the material.
 METAZA Driver online help ("[Correction]
tab" > "[Material Details] dialog box")
Making the [advance] setting
[Advance] is available only when Print
Mode is [Other].
 METAZA Driver online help ("[Correction]
tab" > "[Material Details] dialog box")
Click [OK].
[Advance] window close.
Impact--MAX
350 to 450
400 to 500
500 to 600
93