Table of Contents
Advertisement
3-2 Getting Ready
When material is too large to be placed within the table
Material
If you're performing printing with head cap used, this completes loading of the material.
If you're performing printing with no head cap used, then go on to the following steps.
The procedure from this point on is for when you're not using the head cap.
Stopper
38
Chapter 3 Making Prints
Adhesive
sheet
Center of the
material
Center Line
Knob
Place the material in a way that the
center of the printing area comes to
the center of the scale on the table.
If the material tilts, place a support
in order to keep the material hori-
zontal.
Center
Line
Press the Power/Movement but-
ton.
The head moves and stops at the position
where the tip of the head cap rides on the
surface of the material.
Loosen the knob.
Rotate the knob counterclockwise once.
Then you can move the stopper.
Hide quick links:
Advertisement
Table of Contents
