Roland Metaza MPX-90 User Manual page 37

Conditions for Material When Printing Curved Surfaces *5
The table and figure below show the printing-assured area and the area reached by the marking pin with
respect to the diameter of the cylinder. Note, however, that the following conditions are assumed.
 The head cap is used.
 The material has circularity.
Diameter of cy- Recommended printable area
lindrical material
10 mm (0.3 in.)
20 mm (0.7 in.)
30 mm (1.1 in.)
*5
For printing on curved surfaces, regardless of the shape or composition of the material, the image quality of
photographic data cannot be assured.
(A)
2.0 mm (0.079 in.)
2.8 mm (0.11 in.)
3.4 mm (0.14 in.)
Area reached by the marking
pin (B)
2.8 mm (0.11in.)
4.0 mm (0.16 in.)
4.8 mm (0.19 in.)
Chapter 3 Making Prints
3-2 Getting Ready
35