Roland Metaza MPX-90 User Manual page 36

3-2 Getting Ready
Cross-section of printing material
When using an adhesive sheet or a center vice.
 There must be no unevenness on the print surface. *4
Not OK
Edge of the material is
too high.
*4
Materials that cannot be used are those of which unevenness comes into contact with the moving part of the
machine when material is set or when printing is made.
When using an adhesive sheet.
 The back surface must be flat, with no difference in level.
Not OK
Back surface
is curved.
Without a head cap
The printed surface must be level.
Not OK
Surface to print
is not straight.
34
Chapter 3 Making Prints
Not OK
L-shape
Not OK
Back surface
is uneven.