Sony EVI-H100V Operating Instructions Manual page 40

Polarity of the plug
Bottom
O BOTTOM switches
Used for RS-232C and RS-422
switching, 9,600bps and 38,400bps baud
rate selection, D70 mode switching and
IR signal output setting. For detailed
information, refer to the Technical
Manual of the camera.
P Tripod screw hole
Q Ceiling bracket mounting screw
holes
Important
The nameplate is located on the bottom.
Setting of the SYSTEM SELECT
switch
This switch allows you to select the video
format of the signal to be output from the
VIDEO OUT connectors.
40
Location and Functions of Parts and Controls
Notes
• Be sure to set this switch before you turn
on the power of the camera. You can also
set this switch in the standby mode of the
camera. After completing the setting, turn
on the power of the camera by connecting
it to an AC outlet using the AC power
adaptor and AC power cord or by using the
VISCA command.
• Be sure to use a Phillips-head screwdriver
when changing the switch position. If you
use a tool other than the designated
screwdriver, the crossed groove may be
damaged.
• This camera does not include a function
that automatically selects video output
signals based on the DVI monitor's
resolution. Be sure to configure settings
based on the monitor manually. (EVI-
H100V)
• HDTV video signal outputs display
without distortion on monitors with 16:9
aspect ratios.
EVI-H100S/H100V
Set this arrow to
the desired video
format.