Precautions For Installation - Panasonic WJ-GXE500E Installation Manual

Precautions for Installation

Installation work shall be performed in accordance with the technology standard of the
electric installation.
This product is designed to be used
indoors.
This product is not operable outdoors.
Do not expose this product to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this product away from water and
moisture.
Installation place
• Place the unit correctly on a level surface.
• Do not place the unit in the following plac-
es:
• Locations where it may get wet from
rain or water splash
• Locations where a chemical agent is
used such as a swimming pool
• Locations subject to humidity, dust,
steam and oil smoke
• Locations in a specific environment
where a solvent or a flammable atmo-
sphere exists
• Locations where a radiation, an X-ray,
a strong radio wave or a strong mag-
netic field is generated
• Locations where corrosive gas is pro-
duced, Locations where it may be
damaged by briny air such as sea-
shores
• Locations where the temperature is
not within –10 °C to +50 °C {22 °F to
122 °F}.
• Locations subject to vibrations (This
product is not designed for on-vehicle
use.)
• Locations subject to condensation as
the result of severe changes in tem-
perature
12
Be sure to remove this product if it is not
in use.
Radio disturbance
When this product is used near TV/radio anten-
na, strong electric field or magnetic field (near a
motor, a transformer or a power line), images
may be distorted and noise sound may be pro-
duced.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.
Router
When connecting this product to the Internet,
use a broadband router with the port forward-
ing function (NAT, IP masquerade).
Refer to the Operating Instructions (PDF) for
further information about the port forwarding
function.
SIGNAL GND terminal
Connect this terminal with the SIGNAL GND
terminals of the devices in the system for signal
ground.
When operating this unit and the devices in the
system without signal ground, oscillation or
noise may be produced.
Heat dissipation
To prevent this product from overheating, heed
the following. Failure to observe this may cause
fire or trouble.
• Do not block the ventilation openings.
Maintain the unit periodically to prevent
dust from blocking openings.