Table of Contents
Advertisement
C
C
HECKING CONNECTORS
HECKING CONNECTORS
Check for corrosion, damp etc. in the connectors.
1. Disconnect:
- Connectors
2. Dry each of the terminals with compressed air.
3. Connect and disconnect two or three times.
4. Pull the conductor to check if it is loose.
5. If the terminal comes loose, bend the pin (1) and refit
the terminal in the connector.
6. Connect:
- Connector
N.B.
THE TWO PARTS OF THE CONNECTOR MAKE A SOUND
WHEN THEY FIT TOGETHER.
7. Check the circuit with a Multimeter.
N.B.
- IF THERE IS NO CIRCUIT, CLEAN THE TERMINALS.
- FOLLOW THE STEPS FROM (1) TO (7) ABOVE ON INSPEC-
TING THE ELECTRICAL SYSTEM.
- AS A PROVISIONAL SOLUTION, USE A CONTACT CLEANER.
- USE THE MULTIMETER IN ACCORDANCE WITH THAT IN-
DICATED IN THE FIGURE.
219
Advertisement
Table of Contents
