Chapter 1: Introduction; About This Guide; Setup Overview - Honeywell MX7 Tecton User Manual

Chapter 1: Introduction

The MX7 Tecton Battery Charger is designed to simultaneously charge four rechargeable Lithium Ion (Li-Ion) battery packs.
The time required for charging is dependent upon the battery pack temperature and conditions.
The battery charger should be located in an area where it:
Is well ventilated.
l
Is not in high traffic areas.
l
Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
l
Has enough clearance to allow easy access to the power port on the back of the device.
l
Is protected from rain, dust, direct sunlight or inclement weather.
l
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell batteries sealed inside the mobile device, if any.

About this Guide

This MX7 Tecton Battery Charger User's Guide is intended to familiarize the user with the safety and operating instructions
necessary to use the MX7 Tecton Battery Charger (Model MX7390CHARGER, MX7391CHARGER) to charge rechargeable
lithium-ion battery packs (MX7A380BATT, MX7A381BATT, MX7392BATT, MX7393BATT, MX7A396BATT) .
This guide should be readily available to all users and maintenance personnel using this battery charger.

Setup Overview

The following instructions are abbreviated and intended to give an overview of the process to be followed.
1. Assemble the power supply.
2. Connect the power supply to the charger.
3. Insert a battery into a charging bay.
4. When the battery is charging, the setup process is complete.
Note: Store the charger and batteries when not in use in a cool, dry, protected place.
Please refer to the MX7 Tecton User's Guide for instruction when inserting and removing batteries.
1-1