1/4" Diskette Drive - IBM 5150 Hardware Reference Manual

5-1/4"
Diskette Drive
The IBM 5-1/4" Diskette Drive is a single sided, double density, 40
track unit. The Diskette Drive has a formatted capacity of 163,840
bytes, and is capable of reading and recording digital data using
Modified Frequency Modulation (MFM) methods. User access for
diskette loading is provided by way of a slot located at the front
~
of the unit.
The Diskette Drive is fully self-contained and requires no operator
intervention during normal operation. The Drive consists of a spindle
drive system, a head positioning system, and read/write/erase system.
When the front latch is opened, access is provided for the insertion of a
diskette. The diskette is positioned in place by plastic guides, and the
front latch.
In!
out location is ensured when the diskette is inserted until
a back stop is encountered.
Closing the front latch activates the cone/clamp system resulting in
centering of the diskette and clamping of the diskette to the drive hub.
The drive hub is driven at a constant speed of 300 rpm by a servo
controlled DC motor. In operation, the magnetic head is loaded into
contact with the recording medium whenever the front latch is closed.
The magnetic head is positioned over the desired track by means of a
4-phase stepper motor/band assembly and its associated electronics.
This positioner employs a one-step rotation to cause a I-track linear
movement. When a write-protected diskette is inserted into the Drive,
the write-protect sensor disables the write electronics of the Drive and
an appropriate signal is applied to the interface.
When performing a write operation, a 0.33 mm (0.013-in.) data track
is recorded. This track is then tunnel erased to 0.30 mm (0.012 in.).
Data recovery electronics include a low-level read amplifier, differen­
tiator, zero-crossing detector, and digitizing circuits.
All
data decoding
is provided by the adapter card.
The Drive is also supplied with the following sensor systems:
(I) A track 00 switch which senses when the Head/Carriage
assembly is positioned at Track 00.
(2) The index sensor, which consists of a LED light source and
phototransistor, is positioned such that when an index hole is ,.-......,
detected, a sigital signal is generated.
2-110