Table of Contents
Advertisement
Page
26
This "Priority Part" depends on the current situation. If you only have one Part active, regardless of which Part it
is, the preset effect settings for that sound will be used. If you have two or more Parts active, then the CP will treat
one of them as the Priority Part, and ignore the settings of the other(s).
If the the Effect For Sound is set to "Panel" in the System then the Preset effect settings for each Sound will be
ignored and the Part Priority will be ignored. (See Effect For Sound on page 98).
Here are some guidelines for Effect Priority:
3
Example
Assume that your CP is set up according to the following chart.
If you then select a different sound for RIGHT1, the Effect setting for the RIGHT2, LEFT will be turned off
automatically. This is because RIGHT1 is the Priority Part.
The chart would now look like this:
Priority is given to the Parts in the following order: RIGHT1 > RIGHT2 > LEFT. This means that anytime the RIGHT1
Part is active, its Effect settings will be used, not only for its sound but for any sound in any other Part, that you want to
add effects to. Likewise, the only time an active LEFT Part's settings will be applied is if the other 2 Parts are inactive.
Unless you change them, the Effect settings will only change in response to a change in the Priority Part being activated/
deactivated, or a new sound is assigned to an active Priority Part. In the latter case, the new Effect settings will reflect
the Preset effect settings for the new sound.
When the Effect settings change for the Piority Part, the Effects will be automatically turned off for the other Parts.
You can, however, turn the effect on for any Part by adjusting the Effect On/Off option in the display for that Part.
RIGHT1
Part
Active
Effect
On
RIGHT1
Part
Active
Effect
On
RIGHT2
LEFT
Inactive
Active
Off
On
RIGHT2
LEFT
Inactive
Active
Off
Off
Advertisement
Table of Contents
