Kawai Concert Performer CP3 Owner's Manual page 137

3. Place the Main Unit (A) on the front half of the stand so that the
metal fitting holes are seen when viewed from the top. Slide the
piano backward while holding it with one hand so that it does
not incline and fall from the stand. The hooks on the piano are
then engaged with the metal fittings on the Side Panels. Pay
attention so that hands or fingers are not caught between the
stand and piano. Fasten the piano and the stand with four
short bolts (with plain washers and spring washers) (K).
First, loosely tighten the bolts to adjust the unit position in order
to make sure that all four bolts can be inserted straight, then
tighten the bolts. Make sure that the bolts are tightened until
the spring washers collapse.
Ensure that the CP3 digital piano is correctly secured to the stand by using the bolts included.
Caution
Failing to do so may result in the unit falling from the stand, causing damage or personal injury.
4. Attach the bottom of the End Panel (E) to the bottom of the
Side Panel (B) using the Velcro fastening tape. Then attach
the top of the End Panel to the top of the Main Unit (A). Finally,
secure the panels using two Long Bolts (J) on either side.
Turn the Adjuster anti-clockwise, extending the bolt until it
makes contact with the floor and supports the pedals firmly.
The pedal board may break if the adjuster is
Caution
not touching the floor correctly. When moving
the CP3 digital piano, ensure that the unit is
lifted clearly from the floor and not dragged.
5. Insert the pedal connection cord that comes from Pedal Board
(C) into the piano's pedal jack and fasten with cord clamps..
Connect the power cable to the AC IN terminal on the base
of the main body, then pass the cable through the back board
aperture, and out to the rear of the instrument.
6. Attach the music rack by first positioning it slightly to the right
of centre of the instrument.
Then slide the music rack to the left to lock it into position at
the centre of the instrument.
* In order to remove the music rack, first raise it slightly, then
slide it to the right.
7. A headphone hook (M) is included with the CP3 digital piano
and can be used to hang headphones when not in use.
If desired, attach the headphone hook to the underside of the
main Unit using the two tapping screws (N) provided.
pedals firmly. pedals firmly.
Page
137
A
E
B
J
F
10