Panasonic PV-455S-K Operating Instructions Manual page 4

Connections / Initial Setup (Ready to Play)
Make all cable or antenna connections before plugging into an AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
Connecting (Select a method)
For ANT./Cable
Connect cable from
1
Antenna/Cable to VCR's IN
FROM ANT. jack.
Connect VCR's OUT TO TV
2
jack to TV's ANT. IN jack
with included RF Cable.
For DSS/Cable Box
Connect your cable box's OUT
1
jack to the VCR's IN FROM
ANT. jack with an RF cable.
2 Connect VCR's OUT TO TV
jack to TV's ANT. IN jack with
included RF Cable.
Initial Setup (Ready to Play)
1
Turn TV on and tune to channel 3.
2
Plug VCR Power Cord into AC wall outlet.
VCR comes on and SELECT LANGUAGE
screen appears. When one of "1", "2", "3"
keys is pressed, auto channel and clock set
starts.
• If screen below does not appear...
check all connections.
Try tuning TV to channel 4.
• To change VCR's output channel, please
refer to "VCR's Output Channel" (p. 11).
• If wrong language is set, do "Reset All VCR
Memory Functions" (p. 10).
Plug VCR Power plug into an AC wall outlet.
SELECT LANGUAGE
ENGL I SH :PRESS
FRANÇA I S :APPUYER
ESPAÑOL :OPR I M I R
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
If you use a cable box, turn it on and set it to the
Public Broadcasting Station (PBS) channel in
your time zone. If you use a DSS receiver, it
must be turned off.
Notes
• Function buttons are void during Initial Setup.
• To eject a tape during Auto Set, press EJECT
on remote or STOP twice on VCR.
Then make settings manually. (See p. 11.)
• If Auto Clock Set takes more than 30 minutes,
press STOP and perform settings manually.
(See p. 11.)
VCR TV
VCR
Select language
Press 1 : English
1
Press 2 : French
2
3
Press 3 : Spanish
TV
Over tightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
3
Settings are made automatically.
When complete, this screen appears.
If "AUTO CLOCK SET IS INCOMPLETE"
appears, manually set clock (below).
Manual Clock Set
If Auto Clock Set was incomplete.
1
Press ACTION* on remote to display
CLOCK menu.
2
Press
In the same manner, select and set the
date, year, time, and DST (Daylight Saving
Time).
3
Press ACTION to start clock and exit.
- 4 -
2
2
AUTO CLOCK SET
IS I NCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACT I ON KEY
to select the month and
1
1
to set.