4.10 Keyboard holder/Keyboard
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-11 to 4-13.
1. Place the keyboard face down on the palm rest.
2. Connect the keyboard cable to the connector CN3230 on the system board.
3. Stick the water drop insulator.
4. Turn the keyboard face up and set it. Make sure that there is no gap between the
keyboard and the edge of the cover.
5. Secure the keyboard and keyboard hold plate with the following screws.
• M2×3Z
6. Install the speaker cover.
PORTEGE S100 Maintenance Manual (960-508)
S-FLAT HEAD screw
4 Replacement Procedures
×3
4-27