4 Replacement Procedures
4.5
Expansion memory
Removing the expansion Memory Module
To remove the expansion memory module, make sure the computer is in boot mode and
powered off, follow the steps below and refer to Figure 4-4.
CAUTION: The power must be turned off when you remove/insert the memory module.
Removing/inserting a memory module with the power on might damage the
module or the computer itself.
Never press hard or bend the memory module.
1. Turn over the computer.
2. Loosen the screw (with e-ring) fixing the memory slot cover and remove the
memory slot cover.
3. Press the two latches outward and remove the memory module.
Screw (with e-ring)
Figure 4-4 Removing the expansion memory module
4-12
Latch
Memory module
PORTEGE S100 Maintenance Manual (960-508)
4.5 Expansion memory
Memory slot cover
Latch