Table of Contents
Advertisement
DO NOT OPeRaTe THIS aPPLIaNCe WITHOUT FRONT PaNeL INSTaLLeD.
• Due to high temperatures the appliance should be located
out of traffic and away from furniture and draperies.
• Children and adults should be alerted to the hazards of
high surface temperatures and should stay away to avoid
burns or clothing ignition.
• Young children should be carefully supervised when they
are in the same room as the appliance.
• Clothing or other flammable material should not be placed
on or near the appliance.
• Any safety screen or guard removed for servicing an
appliance must be replaced prior to operating the
appliance.
• Keep burner and control compartment clean.
• Vent cap hot while furnace is in operation.
• Installation and repair should be done by a qUALIFIED
SERVICE PERSON. The appliance should be inspected
before use and at least annually by a qualified service
person. More frequent cleaning may be required due to
attention: The DV-55IPT direct vent wall furnaces are provided with vent kit, DV4T-59-1 for wall depths of 5" to 9". For wall depths
greater than 9", refer to accessories, Page 6. Listed below are the vent kits.
attention: The minimum wall depth for installation of a DV-55IPT MUST BE 5". If the wall depth is less than 5" you can order DV-
822, refer to accessories, Page 6 or refer to Figure 10 and Figure 11 with accompanying text, Page 11.
13281-9-0709
IMPORTANT SAFETY INFORMATION
THIS IS A HEATING APPLIANCE
VEnt KIt InFoRMAtIon
excessive lint from carpeting, bedding materials, etc. It
is imperative that control compartments, burners and
circulating air passageways of the appliance be kept
clean.
• Do not put anything around the furnace that will obstruct
the flow of combustion and ventilation air.
• Do keep the appliance area clear and free from combustible
material, gasoline and other flammable vapors and
liquids.
• Do examine venting system periodically and replace
damaged parts.
• Do make a periodic visual check of pilot and burners.
Clean and replace damaged parts.
• CAUtIon: Pilot hole cover must be kept tightly closed
during operation.
• Do not use this heater if any part has been under water.
Immediately call a qualified service technician to inspect
the heater and to replace any part of the control system
and any gas control which has been under water.
NO.
PART DESCRIPTION
1
OUTLeT TUBe - INNeR
2
GaSKeT - OUTeR COLLaR
3
OUTLeT TUBe - INNeR
4
INLeT TUBe - INNeR
5
GaSKeT - INLeT COLLaR
6
INLeT TUBe - INNeR
7
INLeT TUBe - OUTeR
8
OUTLeT TUBe - OUTeR
9
VeNT CaP
HaRDWaRe KIT
VEnt KItS
DV4T-59-1
DV4T-812-1
DV4T-1219-1
13057
13057
M-177
M-177
13104
13104
13062
13062
M-178
M-178
13106
13106
13064
13065
13059
13060
13053
13053
13078
13078
13058
M-177
13105
13063
M-178
13107
13066
13061
16053
13078
Page 3
Advertisement
Table of Contents
