Table of Contents
Advertisement
Continued
B
8. Gently flare the braid with your fingers (see
Figure 60).
9. Insert the end of the cable into the connector
body until the dielectric is firmly seated
inside the connector (see Figure 61). Be sure
all braid wires remain on the outside of the
connector.
10. Trim any excess braid (see Figure 62), if
necessary. The braid should assemble flush to
within 1/16" (1.6 mm) of the connector
shoulder.
11. Slide the ferrule over the braid until it is flush
against the connector shoulder (see
Figure 63).
32
Terminating LMR-400-75 Cables
Figure 60: Flaring the Braid
Figure 61: Pushing On the Connector
Figure 62: Trimming the Braid
Figure 63: Sliding the Ferrule Over the Braid
Advertisement
Table of Contents
