Table of Contents
Advertisement
PLEASE READ!
Important Addendum to the Installation Guide
Two LMR-400-75 pigtail cables and rubber connector washers are
provided in the kitpack. Follow the steps below, while referring to
Figure 1, to connect these cables in-line between the antenna and the
customer's RF cables, providing a reliable, weatherproof connection to
the antenna.
IMPORTANT!
Use of the supplied pigtail cables is mandatory for every new
installation. Do not connect the customer's RF cables directly to the
antenna.
NOTE: Before you begin, be sure you have properly terminated, labeled, and
routed the customer's "TX" and "RX" RF cables, as explained in the
Installation Guide.
Figure 1 LMR-400-75 Pigtail Connections
P
I
G
T
A
I
L
1. Clean and dry the antenna's two RF connectors and the
RF cables' connectors.
2. Heat shrink is supplied with each pigtail cable to protect
the connection between the customer's RF cables and the
pigtail cables. Slide a heat shrink sleeve onto the end of
each pigtail cable (opposite the boot end) for later use.
54-0841 Rev. A
Antenna Baseplate
Rubber Washer
Apply Silicone Grease
Feed-thru Adapter
Rubber Boot
Apply Silicone Grease
A
A
P
I
G
T
A
I
L
Seal connection with
silicone sealant or
self-vulcanizing tape,
then apply heat-shrink
To Modem
RF Cable Pigtails
Addendum
1
Advertisement
Table of Contents
