Table of Contents
Advertisement
Continued
B
5. Using a utility knife, carefully remove any
residual plastic from the center conductor, if
necessary (see Figure 56).
6. Insert the end of the cable into the #2 end of
the ST-400EZ stripping tool (see Figure 57).
Then rotate the tool clockwise around the
cable until the tool turns easily. This removes
the cable jacket from the end of the cable,
exposing the braid and dielectric (see
Figure 58).
7. Using the DBT-02 tool, deburr and chamfer
the center conductor (see Figure 59). Avoid
nicking the aluminum tape covering the
dielectric.
Terminating LMR-400-75 Cables
Figure 56: Removing Plastic Residue
Figure 57: Stripping the Cable Jacket
Figure 58: Cable Stripped, Exposing Dielectric
Figure 59: Deburring the Center Conductor
31
Advertisement
Table of Contents
