The Central Spout - Miele CVA 5060 Operating And Installation Instructions

The central spout

^ Pull the central spout down as far as
it will go (a), and pull the cover
forwards to remove.
^ Turn the cover around, push the
insert up and out and then clean both
parts thoroughly.
^ Slide the insert back into the cover
until it clicks into place.
^ Pull the jets out of the central spout.
Cleaning and care
^ Remove the two rubber stoppers
(a), and manually clean these and
the jets thoroughly.
If required, remove the bypass tube
(b) as well. You can loosen possible
blockages in the bypass tube by
kneading it with your fingers or
blowing air through it.
Do not use a pin or other sharp
object as these will damage
components.
^ Replace the stoppers.
^ After cleaning, push the jets firmly
back into place on the central spout,
ensuring they are secure.
^ Replace the cover and then push the
central spout back up into position.
51