Before Using Your Multiblender - Sunbeam MultiBlender PB5500 Instruction/Recipe Booklet

Before using your MultiBlender

Important: Always ensure your blender is
unplugged from the power outlet before fitting
or removing the blade assembly. Always
handle the blade assembly with caution,
as the blades are extremely sharp.
Before using your MultiBlender
recommend removing the four-blade system
for thorough cleaning.
To remove the four blade system in the jug
(refer Fig.1)
Unscrew the blade system from the jug by
turning anti-clockwise. Remove the silicone
rubber seal from the blade assembly.
Wash the lid, jug, silicone rubber seal and the
blade assembly in warm soapy water.
Note: When removing the blade assembly
from the jug you may need to slightly tilt the
blade so that it slides out easily.
To re-assemble the four-blade system in the jug
(refer Fig.2)
1.Place the silicone rubber seal
blade assembly, as shown opposite.
2.Position the blade assembly
base of the blender jug
the blade assembly is firmly in place by
turning it clockwise as indicated by the
arrow.
Note: Do not remove the stainless steel blades
from the blade assembly.
™ , we
over the
1
2
­
1
into the
3
. Ensure that
2
3
™
Figure 1
1
2
3
1
2
3
Figure 2
5