Table of Contents
Advertisement
Installing the burn media
Remove combustion chamber glass
Before the burn media can be installed the combustion
chamber glass panel needs to be removed.
1. Remove the two retaining screws that secure the
combustion chamber glass panel to the heater engine.
2. Rotate and lift the combustion chamber glass clear of
the combustion chamber and place in a safe location
until required.
Installing the small black stones
Place stones in the gap between the glass
retaining wall and the stainless steel burner
shelf until it has been completely filled. Place
remaining stones evenly (AVOID any large gaps)
onto the burner shelf.
Important
DO NOT place the stones on top of or above the
level of the glass retaining wall, or place onto the
burner plates.
14 | Arriva 752 Installation Guide: 12218-D 04-14
Glass retaining wall
Stones
Burner shelf
Retaining
screws
Installing the large and small white quartz
1. Place the six large quartz pieces evenly along
the centre of the burner shelf.
2. Place the small quartz pieces in the gap
between the glass retaining wall and the
burner shelf until it has been completely
filled— AVOID any large gaps.
3. Place the remaining small quartz pieces evenly
around the six large quartz pieces on the
burner shelf.
1.
Small quartz
2.
Burner shelf
Large quartz
Small quartz
3.
Burner shelf
Important
DO NOT place the quartz on top of or above the
level of the glass retaining wall, or place onto the
burner plates.
Combustion
chamber glass
Large quartz
Glass retaining wall
Burner shelf
Glass retaining wall
Glass retaining wall
Advertisement
Table of Contents
