Using Lxeconnect - Honeywell MX7 Reference Manual

Using LXEConnect

1. If an ActiveSync connection is has not been established, connect the MX7 to the PC.
2. Double-click the LXEConnect icon that was created on the desktop.
3. LXEConnect launches.
4. Click the OK button to dismiss the About CERDisp dialog box (shown above) on the MX7desktop by clicking the OK
button in the LXEConnect window on the PC desktop. The dialog box automatically times out and disappears after
approximately 30 seconds.
5. The MX7 can now be configured from the LXEConnect window. Input from the PC's mouse and keyboard are
recognized as if they were attached to the MX7.
6. When the remote session is completed, terminate the LXEConnect program by selecting File > Exit or clicking on the X
in the upper right hand corner to close the application then disconnect the ActiveSync cable.
Note: After using LXEConnect, the MX7 cannot go into Suspend mode until after a warmboot. If using
Power Management on a MX7, always warmboot the MX7 when finished using LXEConnect.
5-9