Function And Temperature Switch Modules; Function And Temperature L.c.d. Modules And Lenses - Fisher & Paykel Titan AeroTech OD302-B Service Manual

Service Manual 599337A: 302B Series Titan Oven

7.6 Function and Temperature Switch Modules

Location: Control Panel
Removal
1. Follow the general servicing instructions for components around the control panel
area. (refer to Section 7.2)
2. Remove the temperature/oven mode knobs and the clock twist button.
Note: To best work on the control panel turn it face down and place blocks of
polystyrene under the ends to elevate it off the working surface.
3. Disconnect the earth wire and remove the
mounting panel.
4. Remove the retaining nut and washer from the
faulty module.
5. Disconnect the wiring harness and transfer to
the replacement module.
6. Remove the plastic mounting bracket from the
faulty module and transfer it to the replacement
module.
Reassembly
Refit in reverse manner.
Note: Ensure the wiring harness wires are clear of possible crush points during
reassembly.
Follow the reassembly procedure. (refer to Section 7.5)

7.7 Function and Temperature L.C.D. Modules and Lenses

Location: Control Panel
L.C.D Modules:
Removal
1. Follow the general servicing instructions for components around the control panel
area. (refer to Section 7.2)
2. Remove the temperature/oven mode knobs and the clock twist button.
3. Disconnect the earth wire and remove the mounting panel.
4. Unclip the faulty module from the retaining lens and lift out.
5. Disconnect the wiring harness and transfer it to the replacement module.
Note: Take care not to leave fingerprints or visible marks on any lens surface.
Reassembly
1. Remove the protective strip from the L.C.D module screen.
2. Refit in reverse manner.
Note: Ensure the wiring harness wires are clear of possible crush points when
reassembling.
Follow the reassembly procedure. (refer to Section 7.5)
47
July 2006
Mounting Bracket
Figure 7.6