Table of Contents
Advertisement
INsTALLATION
How you install your CS2000M
4
will depend on what type of equip-
ment you have. To determine which
setup procedure you should follow,
check to see if your equipment has a single
or double connection for the RCA Adaptor
(D or F). If you have a double, your tele-
vision is a stereo television (use Adaptor
Cord D). If you have a single, it is a mono
television (use Adaptor Cord F).
It is also important to note that because
not all TVs are the same, when you plug
something into the audio output jack, one
of two things will happen.
1. The sound from your television will be
automatically cut off and nobody else
in the room will be able to hear the TV.
This is okay if you don't want anyone
else to be able to hear the television
but bad if you just want to listen at a
higher volume than others in the room.
To have the sound continue to come out
of your television speakers, you must
either use the microphone adaptor or
connect the Transmitter to your VCR
(see VCR installation below).
2. The sound will continue to come out of
the TV speakers. This is okay if other
people want to listen as well, but not if
you want to be able to hear exclusively
through the headphones. Furthermore,
if you turn the volume down a lot, you
may reduce the signal going to the TV's
audio output jack(s) (see Muting the
Television Sound).
First, for all installations, insert the
plug of the AC/DC Transformer (C)
into the DC 12V input connection on
the back of the Infrared Transmitter
(A) as shown in Diagram 1 and then
plug the transformer into your electrical
outlet. Now choose the installation that
matches your equipment.
Advertisement
Table of Contents
