Related Manuals for ClearSounds CS2000M
Summary of Contents for ClearSounds CS2000M
- Page 1 OWNER'S MANUAL WIRELESS TV LISTENING SYSTEM with Dual Ear Volume Control Model CS2000M 95 KHz Frequency...
-
Page 2: Table Of Contents
ClearSounds® CS2000M. NOTE: CS2000M is not suitable for use with Plasma and LCD flat screen TVs. If you are having any difficulty, please call our help desk at... -
Page 3: How It Works
HOW IT WORKs The transmitter sits on your audio adjust the volume on the cordless source (TV/VCR, stereo, etc.) and headphones to suit your personal transmits an audio signal via infrared needs. Multiple headphones can light. The receiver in the headphones be used with one transmitter. -
Page 4: Installation
INsTALLATION How you install your CS2000M to listen at a higher volume than oth- will depend on what type of ers in the room. To have the sound equipment you have. To determine continue to come out of your televi-... - Page 5 to the audio output jacks as shown in Diagram 1 DC in 12 Volt Diagram 2. Be sure to connect the Power adaptor to the audio output and not the video output. Audio in Mono Installation – for use with TVs, VCRs, or stereos that have your equipment.
- Page 6 Adaptor (E) and insert it into the head- Small Headphone Jack phone jack as indicated in Diagram 5. Installation – for use with equip- VCR Installation – for use when you ment that has a small headphone have cable passing through your VCR jack.
-
Page 7: Installation
As an alternative to using the micro- Microphone Installation – for use when phone, if your television has a your equipment does not have an audio cable box, locate an audio output output jack. Connect the Transmitter jack on the back panel of the cable (A) to the Microphone Adaptor (G). -
Page 8: Placement Of Transmitter
tive and negative to negative. Turn on PLACeMeNT OF THe TRANsMITTeR the headphones making sure there is an unobstructed line of sight between the headphones and the Transmitter. Adjust Turn on the Infrared Transmitter the television volume and the headphone (A). -
Page 9: Troubleshooting
TROUBLesHOOTING probLem possibLe CAuse - AC Adaptor is not plugged in red power light - AC plug is not plugged into the transmitter is not on - The audio cord is not plugged into the audio source - There is no audio output from the audio source - The audio cord is not plugged into the audio source no sound from - There is no audio output from the audio source... -
Page 10: Technical Specifications
TeCHNICAL sPeCIFICATIONs Transmission Mode ....Infrared 940 nanometers Frequency Modulation (95KHz) Operating Voltage ....Transmitter - 12 VDC via 120 VAC, 60 Hz AD/DC adaptor Frequency Response . -
Page 11: Limited Warranty
Center listed below. consequential damages so the above limitation or exclusion may not apply to NOTE: Prior to returning any CS2000M you.) This warranty does not cover (1) ® to the ClearSounds Service Center,... - Page 12 Need Help Hearing On The Telephone? Visit: www.clearsounds.com 8160 S. Madison Street Burr Ridge, IL 60527 Tel: 1-800-965-9043 / TTY: 1-800-814-5369 © 2007 ClearSounds P/N: R907770121...