JVC KD-LX330R Instructions Manual page 69

To select the external component to use
—
EXT INPUT
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adaptor KS-U57 (not supplied).
To use the external component as the playback
source through this unit, you need to select
which component — CD changer or external
component — to use. When shipped from the
factory, "CHANGER" is selected as the external
component.
• CHANGER: To use the CD changer
• LINE INPUT: To use the external
component other than the CD
changer
To make the front panel look flat (hiding
the control panel) —
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat. When shipped from the
factory, "FLAT OFF" is selected.
• FLAT ON: The control panel will not
come out when you turn on
the unit.
To use the control panel,
press 4
control panel comes out. If no
operation is done for about
10 seconds, it automatically
goes back into the receiver.
• FLAT OFF: You can use the control panel
normally.
Note:
When "FLAT ON" is selected, you can eject a CD by
holding 4
.
FLAT PANEL
so that the
To change the FM tuner selectivity
—
IF FILTER
In some areas, adjacent stations may interfere
with each other. If this interference occurs, noise
may be heard. This unit has been preset to
automatically reduce this interference noise
("AUTO") when shipped from the factory.
• AUTO: When this type of interference
occurs, this unit automatically
increases the tuner selectivity
so that interference noise will
be reduced. (But the stereo
effect will also be lost)
• WIDE: Subject to the interference
from adjacent stations, but
sound quality will not be
degraded and the stereo
effect will not be lost.
To turn the demo mode on or off
—
DEMO MODE
You can turn the demo mode on or off. When
shipped from the factory, "DEMO ON" is
selected.
• DEMO ON: Turns the demo mode on. The
demonstration will start
automatically if no sound
comes in for 3 minutes.
• DEMO OFF: Turns the demo mode off.
Note:
If the unit has been reset (and the power is on),
demonstration will start if no sound comes in for
about 10 seconds.
25