Gigabyte MNIC8PI User Manual page 34

LBA/Large Mode
Configure the device type in the specific IDE channel support LBA Mode.
Option available: Auto/Disabled. Default setting is Auto.
Block (Multi-Sector Transfer)
Configure the information of Multi-Sector Transfer Mode.
Auto:
The data transfer from and to the device occurs multiple sectors at a time if the device
supports it.
Disabled:
The data transfer from and to the device occurs one sector at a time.
Option available: Auto/Disabled. Default setting is Auto.
PIO Mode
This feature allows you to set the PIO (Programmed Input/Output) mode for the two IDE devices (Master
and Slave drives) attached to that particular IDE channel.
Option available: Auto/Disabled. Default setting is Auto.
PIO Mode
This feature allows you to set the PIO (Programmed Input/Output) mode for the two IDE devices (Master
and Slave drives) attached to that particular IDE channel.
Option available: Auto/Disabled. Default setting is Auto.
DMA Mode
Configure the DMA mode of the device in the specific IDE channel.
Option available: Auto/Disabled. Default setting is Auto.
S.M.A.R.T Mode
This feature allows you to set the PIO (Programmed Input/Output) mode for the two IDE devices (Master
and Slave drives) attached to that particular IDE channel.
Option available: Auto/Disabled. Default setting is Auto.
32Bit Data Transfer
Configure the 32Bit Data Transfer rate.
Option available: Auto/Disabled. Default setting is Auto.
Hard Disk Write Protect
Enable/Dsable Hard Disk Write Protect function.
Options available: Enabled/Disabled/Enhanced. Default setting is Enhanced.
IDE Detect Time Out (Sec)
This item allows you to force BIOS to delay the initialization of Hard drive devices up to 35 seconds. The
dalay gives your Hard drive devices more time to spin up before the BIOS initialize them.
Press [Enter] to Confiure the Hard disk device unit command timeout.
BIOS Setup - 34 -