16) JFRONT (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status
indicator on the chassis to this header according to the pin assignments below. Note the positive and
negative pins before connecting the cables.
The front panel design may differ by chassis. A front panel module mainly consists of power
switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your
chassis front panel module to this header, make sure the wire assignments and the pin assign-
ments are matched correctly.
Hardware Installation
Pin No.
Pin Definition
1
Stand-by LED Signal
2
Power LED Signal
3
Power Switch
4
Ground
5
LAN Act LED Signal
6
LAN Act LED 5V
7
HDD LED
8
VCC 5V
9
Reset Button
10
Ground
1
2
- 20 -
9
10