Gigabyte MNIC8PI User Manual page 25

32) CLR_CMOS1 (Clearing CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and reset
the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the two pins to
temporarily short the two pins or use a metal object like a screwdriver to touch the two pins for a few
seconds.
• Always turn off your computer and unplug the power cord from the power outlet before clearing the CMOS
values.
• After clearing the CMOS values and before turning on your computer, be sure to remove the jumper cap from
the jumper. Failure to do so may cause damage to the motherboard.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or manually
configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
33)
USB_PWR1/USB_PWR2/USB_PWR3
USB_PWR2
USB_PWR3
USB_PWR1
Hardware Installation
1
1-2 Close: Clear CMOS data)
1
2-3 Close: Normal operation (Default setting)
(
USB Stand-by 5V/VCC 5V Select Jumper
1
1-2 Close: VCC 5V. (Default setting)
1
2-3 Close: Stand-by 5V.
Pin No.
1
2
3
- 25 -
)
Definition
VCC 5V
USB Power input
Stand-by 5V