Superior VRE4543EN Installation And Operation Instructions Manual page 15

Installing Access Door
1. Place access door into rectangular open-
ing in front of the glass door with the
slanted side facing forward. The slanted
surface will slide underneath the flange of
the bottom face Insert tabs on side of ac-
cess door into slots on retaining brackets
(See Figure 22).
Side
Filler
Flange on
Face Bottom
Figure 22 - Access Door for See-Thru
Applications
Installing Hood
1. Install hood as shown on page 13.
Locating Control Module
1. Remove Access Plate (See Figure 22).
2. Remove 2 screws on top of the electronic
access cover (See Figure 23).
3. Remove electronic access cover by gently
pulling up and out of the fireplace. There
are two switches connected to cover.
4. The control module is located on the left
as shown in Figure 24.
Electronic
Access Cover
Figure 23 - Removing Control Access Cover
(Face Bottom not shown for Clarity)
127035-01A
INSTALLATION
Access
Door
Remove
Screws
www.SuperiorFireplaces.US.com
Continued
5. Light switch is located on the right hand
side as shown in Figure 24.
6. ON/OFF switch is located on the left hand
side as shown in Figure 24.
ON/OFF
Switch
Gas
Module
Figure 24 - Control Module (Face Bottom
GLASS PEBBLE INSTALLATION
WARNING: Do not change
or substitute glass pebbles
provided with this fireplace. If
replacing, use only replacement
glass pebbles. See Replacement
Parts page 27.
Green glass pebbles are included with your
fireplace.
1. Place glass pebbles in a single layer
evenly on the pebble pan. Make sure not
to place any on the burner in the center
of the pebble pan.
Remote
Receiver
Backup
Battery
not shown for Clarity)
Light
Switch
15