Real Care Baby II-plus Operating Handbook page 36

Frequently Asked Questions
The control unit does not turn on.
The batteries in the control unit could be low. Change the batteries and try the
control unit again. No data is lost.
Do I have to reset the control unit clock for daylight savings time?
Yes. To reset the clock, select Control Unit from the Main Menu, and then choose
Set Clock. Press the up and down arrows to change the time.
Do I have to reset the control unit clock for leap years?
No. The control unit is designed to take leap years into account.
Can I start Baby without a control unit or Control Center?
No. There is no Emergency Start option with RealCare
How much simulation data can the control unit store?
Data for up to 30 Babies. After data for 30 Babies has been stored in the control
unit, the oldest simulations will automatically be deleted with each new simulation
that is downloaded.
The control unit stays on the "SEARCHING" screen and nothing
seems to be happening.
Baby may not be in the control unit's range for communication. The best control
unit communication areas on Baby are on the upper chest and lower belly region in
both the front and back of Baby. Hold the control unit two inches from one of the
target areas shown on page 6, and hold it steady for fi ve seconds. Do not wave the
control unit around Baby. If the "SEARCHING" screen remains, check the battery
levels of both the control unit and Baby.
The control unit shows a Total Crying Time of 999 minutes.
The largest number possible for crying time is 999 minutes. Crying time includes all
crying for rough handling, wrong position and neglect, as well as scheduled crying
for care.
The control unit is in the wrong language.
Turn the control unit off, then back on. This will bring you to the Main Menu.
1. Scroll down to the last option on the screen and press the right arrow.
2. Again, scroll down to the last option on the screen and press the right arrow.
3. Scroll up to the fi rst option (English) and press the right arrow.
Is the control unit broken when the screen looks like this?
No. You or someone else accidentally selected Japanese for the control unit's
display language. See the answer to the previous
question for instructions on changing the language.
(cont.)
Baby II-plus.
®
36