Real Care Baby II-plus Operating Handbook page 12

2. Configure IDs.
Baby uses wireless IDs to recognize its caregiver. Baby does not allow care without an
ID. You may confi gure two IDs for each Baby (useful for assigning a babysitter). ID 1
is the "parent" and ID 2 (optional) is the "babysitter."
Baby Found!
Name BABY____
Ethnicity/Gender
ID 1 ______
ID 2 ______
Start Data Transfer
Locate Baby
SEARCHING |||||||
"Baby Found!" screen shows new ID number.
ID(s) and Baby together. Baby will not recognize any other ID.
3. Give Baby a New Name (optional).
Baby's name appears on control unit menus and student reports.
Baby Found!
Name BABY____
Ethnicity/Gender
ID 1 ______
ID 2 ______
Name
Change BABY_____
To JAMES
YES
NO
*
This screen does not
appear if you made
no changes.
ID 1
Bring new ID
in range
SEARCHING |||||||
Point at Baby:
listen for chime
(Hold for
4-5 seconds)
Name
B A B Y _ _ _ _
Start Data Transfer
Locate Baby
SEARCHING |||||||
Baby Found!
Name JAMES
Ethnicity/Gender
ID 1 ______
ID 2 ______
12
ID 1
Change
To
YES
NO
Baby Found!
Name BABY____
Ethnicity/Gender
ID 1 (new ID#)
ID 2 ______
Keep the configured
Press to change
Point at Baby:
listen for chime
(Hold for
4-5 seconds)
"Baby Found!"
screen shows
Baby's new
name.
(old ID#)
(new ID#)