Finish The Site Survey; Connect The Cs And Ps To The Pbx And Test The Operation; Mount The Cs On The Wall - Panasonic KX-TDA0141 Quick Installation Manual

c.
Map the CS coverage area at radio signal strength levels "3" and "8".
d.
Make sure that adjacent CS coverage areas overlap where the radio signal strength level is "8" by at least
5 m.
e.
Make sure that the radio signal strength level is greater than "3" at any location within the service area
required by the user.

4. Finish the site survey

Refer to "6 After Site Survey".
a.
Turn off the PS.
b.
Stop supplying power, and return all DIP switches of each CS to the OFF position.

5. Connect the CS and PS to the PBX and test the operation

Refer to "7 Connecting a Cell Station to the PBX".
a.
Connect the CSs to the PBX.
b.
Register the PSs to the PBX.
c.
Walk around the service area while having a conversation using a registered PS. If noise is frequent or
conversations disconnect, relocate the CSs or install an additional CS.

6. Mount the CS on the wall

Refer to "8 Wall Mounting".
a.
If there are no problems in testing, mount the CS on the wall.
2 Procedure Overview
Quick Installation Guide 11