Ipv6 Lan Settings - ActionTec T1200H User Manual

4. Select the IP type. If Single Static IP Address was selected, enter the IP address
in the "Single Static IP" text box. If "Block of Static IP Addresses (Unnumbered
Mode)" was selected, enter the designated gateway IP address and subnet mask
address in the "Modem Address" and "Subnet Mask" text boxes, respectively.
Also, "VIP Mode" can be activated by clicking in the appropriate check box.
VIP mode works in concert with unnumbered mode and allows computers not
assigned a static IP to receive a DHCP LAN side private IP address.
5. Select the DNS type. If static DNS address was selected, enter the primary DNS
address and, optionally, the secondary DNS address in the appropriate
text boxes.
6. If applicable, enter a different MTU value in the MTU text box.
7. Enable or disable IGMP proxy by clicking in the appropriate radio button.
When finished in this screen, click Apply to activate any changes made.

IPv6 LAN Settings

IPv6 LAN Settings allows the user to configure the IPv6 LAN settings on the
Gateway. To configure:
1. Click IPv6 LAN Settings from the menu on the left side of any Advanced
Setup screen. The IPv6 screen appears.
2. Select the LAN connection type from the drop-down menu.
VDSL2/GigE Wireless 11n Gateway
42