ActionTec T1200H User Manual page 9

Rear Panel
The rear panel of the Gateway features 8 ports (Phone, HPNA, LAN Ethernet,
WAN Ethernet, USB, and Power), as well as a Reset button.
DSL Port (Single on T1200H; Dual on T2200H)
The DSL port is used to connect the Gateway to a DSL line connection.
HPNA Port
The HPNA port is used to connect the Gateway to an HPNA connection via
coaxial cable.
LAN Ethernet Ports (4)
The LAN Ethernet ports are used to connect computers to the Gateway via
Ethernet cable. The Ethernet ports are 10/100/1000 Mbps auto-sensing ports,
and either a straight-through or crossover Ethernet cable can be used when con-
necting to the ports.
WAN Ethernet Port
The WAN Ethernet port is used to connect the Gateway to a WAN via an
Ethernet cable.
USB Port
The USB port is used to connect the Gateway to a USB device. This port is not
currently operational, but may be enabled in a future firmware update.
Reset Button
Depressing the Reset button for 5 seconds will restore the Gateway's factory
default settings. The reset process will start after releasing the button.
Chapter 1 Introduction
5