CYBEX Bravo Lift Owner's Manual page 5

Inspect the equipment for worn or loose components prior to use. Tighten/replace any loose or
•
worn components before to using. Pay close attention to belts, cables, grips or pulleys and their
connections. Always look for potential problems in equipment condition. Loose components should
be tightened to function properly. Replacing worn components maintains the equipment is in the
best condition for regular use.
To maximize stability, securely anchor each machine to the floor using the anchor holes provided
•
in each machine. Each machine must be set up, anchored, and operated on a solid level surface.
Do not install equipment on an uneven surface!
D A N G E R !
Cybex is not able to anchor the equipment due to local building codes.
The owner is responsible for the actual anchoring of equipment.
Consult with a professional contractor.
Use fasteners having a minimum of 500 lbs. tensile capacity -- Cybex
recommends 3/8" grade 2 bolts or better.
If legs/frame does not contact surface, DO NOT pull down with
anchors. Shim any leg or frame not in contact with surface using flat
washers.
Ensure that all users are properly trained on how to use the equipment.
•
Verify there is enough room for safe access and operation of the equipment. Spacing
•
requirements for each piece of equipment vary depending on placement. The Assembly section
gives equipment dimensions but it is up to the facility to verify there is clearance between and
around each machine to operate without interference.
Perform regular maintenance checks on the equipment as detailed in the Maintenance section
•
of this manual. Inspect all areas most susceptible to wear, including, (but not limited to) cables,
pulleys, belts, and grips.
Immediately replace worn or damaged components. If unable to immediately replace worn or
•
damaged components then remove from service until the repair is made.
Use only Cybex supplied components to maintain/repair the equipment.
•
Keep a repair log of all maintenance activities.
•
Display the Facility Safety Sign so it is visible and prominent.
•
Cybex 18030 Bravo Lift Owner's Manual
5
Death or serious injury will occur if the
following requirements are not met: