Honda TRX680FA Service Manual page 381

FRONT WHEEL/SUSPENSION/STEERING
BALL JOINT REPLACEMENT
Remove the snap ring from the ball joint.
BALL JOINT
Set the upper arm and special tools with "A" mark
side of the remover/installer facing to the ball joint
as shown.
Press the ball joint out of the upper arm.
TOOLS:
Ball joint remover/installer 07WMF-HN00100
Attachment 28 x 30 mm 07946-1870100
SNAP RING
ATTACHMENT
Set the upper arm and special tools with " B " mark
side of the remover/installer facing to the ball joint
as shown.
Press the ball joint into the upper arm until it is fully
seated.
TOOLS:
Ball joint remover/installer
Attachment, 20 mm I.D.
Attachment, 17 mm I.D.
Attachment, 15 mm I.D.
07WMF-HN00100
07746-0020400 or
07746-0020300 or
07746-0020200
NOTICE
If you feel strong resistance when lowering the
press, stop. Reset the attachment of the tool so the
ball joint head can go into the hollow of the attach-
ment and try again. Failure to reset the attachment
will damage the ball joint and/or the upper arm.
Install the snap ring with the chamfered edge facing
in.
SNAP RING
15-25