Honda TRX680FA Service Manual page 335

DRIVETRAIN SYSTEM
Do not interchange
A and B.
SOLENOID AND EMERGENCY VALVES
Coat a new O-ring with engine oil and install it into
the stopper bolt groove.
Apply engine oil to the emergency valve.
Install the spring and emergency valve into the A/T
clutch pressure control solenoid body with the con-
cave head end portion of valve facing in.
Install the valve stopper bolt and screw it in until the
groove edge is aligned with the valve body surface.
Install the lock plate and screw as shown.
Coat a new rubber seal with engine oil and install it
into the groove in the A/T clutch pressure control
solenoid body.
Install the A/T clutch pressure control solenoid
assembly with the four bolts.
SCREW
STOPPER BOLT
LOCK PLATE
A/T CLUTCH
PRESSURE
CONTROL
SOLENOID
BOLTS
Coat new O-rings with engine oil and install them
into the grooves in each shift solenoid valve.
Install the shift solenoid valve A and B with the
bolts.
Tighten the six solenoid valve bolts and lock plate
screw securely.
B (Brown)
A (Black)
SCREW
INSTALLATION
Clean the mating surface of the valve body assem-
bly and front crankcase cover.
Coat new O-rings with engine oil and install them
into the grooves in the oil joint collars.
Install the four joint collars and a new gasket.
JOINT COLLARS/O-RINGS , *W'
14-53