FUEL SYSTEM (PGM-FI)
Remove the right side screw and loosen the left side
screw.
Remove the bank angle sensor from the left side
grommet.
Route the sensor Install the bank angle sensor with its "UP" mark fac-
wire correctly ing up.
(page 1-20). Tighten the mounting bolts to the specified torque.
TORQUE: 1.5 N m (0.15 kgf m, 1.1 Ibf-ft)
Connect the bank angle sensor 3P (Green) connec-
tor.
Install the right inner fender (page 3-9).
ENGINE STOP RELAY
INSPECTION
Remove the battery and battery case (page 20-6).
Disconnect the relay module 8P (Gray) connector.
8P (GRAY) CONNECTOR
6-52