Desa Amity Owner's Operation And Installation Manual page 9

INSTALLATION
Continued
9. Fasten stove bottom to stove with four (4) M6 x 1 - 25mm
bolts. Use a flat washer and lock washer with each bolt. Tighten
bolts into threaded holes on stove body (see Figure 8, page 8,
and Figure 10). Use an adjustable wrench or a 10mm socket.
10. Attach stove door by inserting step bolt through door hinge pivot
hole and into threaded hole in stove body (see Figure 8, page 8 and
Figure 11). Use an adjustable wrench or a 12mm socket to fasten
step bolt. Tighten step bolt until snug. Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 8, page 8).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 12). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make
final adjustment and door leveling after stove is in normal
standing position.
13. Carefully lift stove back up on its four attached legs.
14. Set top grate into stove top.
15. If available, install gas log heater inside stove cavity before
installing the back panel (see Installing Gas Log Heater Into
Stove, page 10).
16. Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts
and washers. Make sure product identification label is located
on the outside in lower left-hand corner.
Stove
Bottom
Washers
Bolt
Figure 10 - Attaching Stove Bottom (Amity™ Model Shown)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
111162-01B
Stove
Door
Door
Hinge
Step Bolt
Figure 11 - Attaching Stove Door (Appearance May Vary
Depending on Model)
Door
Figure 12 - Catch Bolt and Door Claw Orientation
to the heater base assembly. The data plates contain
important warranty and safety information.
Bottom Of
Stove Unit
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
Stove Cavity Assembly (Cont.)
Threaded
Hole
Stove
Bolt Shoulder
Bottom
Door
Claw
CAUTION: Do not remove the data plates attached
WARNING: Failure to position the parts in accor-
CAUTION: After installation and periodically there-
INSTALLATION
9 9
Stove
Door
Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt Stop
Adjusting
Nut
Catch
Bolt