Checking The Scanner Firmware Version - Xerox DocuMate 5445 User Manual

Checking the Scanner Firmware Version

You will need to know the scanner's firmware version to determine which features are available in the hardware.
Change to the Advanced source configuration mode. Go to the Driver Configuration section and then click on the
scanner tab. The scanner's firmware version is displayed on the left side of this tab.
Note that the scanner's maximum page length varies by scan resolution for some scanners. Please refer to the
information below for your scanner model to determine supported page sizes and hardware features.
Xerox DocuMate 5445 / Xerox DocuMate 5460 — firmware version lower than 2.0
• Maximum page length for all resolutions: 100 inches (2540 mm)
If this is your scanner version, please continue to the
Xerox DocuMate 5445 / Xerox DocuMate 5460 — firmware version 2.0 or higher
• Maximum page length varies by resolution
Resolution
75 dpi*
100 dpi
150 dpi
200 dpi
300 dpi
400 dpi
500 dpi
600 dpi
1200 dpi*
*this is an interpolated resolution which is available with
software Visioneer Acuity only.
If this is your scanner version, please continue to
190 ®
Xerox DocuMate
User's Guide
Scanning
Xerox DocuMate 5445
150 inches (3810 mm)
150 inches (3810 mm)
150 inches (3810 mm)
150 inches (3810 mm)
150 inches (3810 mm)
150 inches (3810 mm)
120 inches (3048 mm)
100 inches (2540 mm)
100 inches (2540 mm)
Hardware Image Processing for Your
®
5445 / 5460
section of this chapter.
Xerox DocuMate 5460
195 inches (4953 mm)
195 inches (4953 mm)
195 inches (4953 mm)
195 inches (4953 mm)
195 inches (4953 mm)
150 inches (3810 mm)
120 inches (3048 mm)
100 inches (2540 mm)
100 inches (2540 mm)
Scanner.