Woodwork And Composites - Four winns 278 VISTA Owner's Manual

Q - 1 HIGH-PRESSURE LAMINATE CARE
Much of the 258 and 278 Vista
such as the shelving, cabinets, hanging lockers and
drawer fronts consist of a high pressure laminate
material. The finish is that of a synthetic cherry and
can be cleaned with hand dish washing soap and
water or other cleaning solutions such as Fantastik
Always read the label before using any product.
NOTICE
DO NOT use abrasive cleaners or solvents on
laminate. DO NOT use Soft Scrub soap or
similar cleaning products; they will scratch the
surface and remove the shine.
Q - 2 CHERRY
Four Winns uses actual cherry wood for the dinette
table. The wood is prepared with a light stain followed
by a polyurethane finish. To clean, a damp cloth will
usually suffice. Care should be similar for cherry as it
is for fine, household furniture. See Figure Q1.
Figure Q1: 258 & 278 Cherry Dinette Tables & Interiors
(Respectively)
Woodwork and Composites - Section Q
interior components
®
.
™

WOODWORK AND COMPOSITES

Q - 3 STAR BOARD
Star board is a high density polyethylene (plastic) and
is very durable and fade resistant. Star board requires
little maintenance, and is being used in place of wood
in many areas of the boat.
To clean star board, use a solvent-free, nonabrasive
cleaner such as hand dish washing soap or Fantastic
Read the label before using any cleaning product.
Star board will stain when exposed to certain
oils or chemicals. Always wipe up any spills
immediately.
Q - 4 LAMINATED FIBERGLASS
Certain components such as cockpit tables, seat
bases, storage tubs, storage lids/doors, ect. may
consist of a laminated fiberglass material. These
components may be cleaned with mild dishwashing
soap and water. After washing, a light coat of wax
may be applied as necessary. Always read the label
before using any product. See Figure Q2.
Figure Q2: Cockpit Table
DO NOT use abrasive cleaners or solvents on
cockpit table. DO NOT use Soft Scrub™ soap
or similar cleaning products; they will scratch
the surface and remove the shine.
DO NOT use cockpit table as a cutting board.
The knife will leave gouges/marks in the
surface of the table.
NOTICE
NOTICE
NOTICE
Owner's Manual Page 
.
™