Four winns 278 VISTA Owner's Manual page 170

7) Zip each partially in place in all directions, then
complete the zipping.
8) Snap to the boat (from the outside if possible).
9) Secure and smooth all velcro closures.
Figure O5: Bimini Side Curtain & Visor Installation
NOTICE
Both the bimini and camper canvas have been
designed and are intended to remain installed
on the boat in the upright "stored" position.
Four Winns does not recommend the bimini
and/or camper assembly be removed from the
boat unless absolutely necessary ie. winter
storage.
NOTICE
The bimini and camper canvas is designed
as temporary shelter only. It should not be left
up unattended for any length of time. Violent
weather could result in expensive damage.
Misues is not covered under warranty.
NOTICE
Two people are recommended if removal or
installation becomes necessary. Care must be
exercised so the radar arch (if applicable) or
interior cockpit area does not become
damaged. Use a protective covering to prevent
damage to arch if necessary.
Weather Covers - Section O
Bimini side
curtains
windshield
visors
NOTICE
In the event the canvas requires some
maintenance or repair, remove the bimini
camper canvas from the bow assembly. Unzip
the bow sleeves, unsnap all snaps and straps,
and remove the canvas.
O - 5 CAMPER
The camper is standard and provides cover/shade
for the aft portion of the cockpit area. It too, is designed
to be fastened to the radar arch (if applicable) with the
use of a track with valance and stainless steel bows
and hardware. For boats without a radar arches
stainless steel bows, stainless steel hardware and
straps are used. The camper aft curtain and camper
side curtains can be installed to enclose the aft cockpit
area. The camper and camper curtains used in
conjunction with the bimini top, forward connector and
bimini side curtains completely encloses the cockpit
area when desired. See Figure O6.
Camper Canvas
Figure O6: Camper Canvas
To install the camper canvas:
1) With the long support poles in the back and
the smaller, storage poles in the front (toward the
radar arch or bow of boat), attach the camper top
frame to the side mounts. See Figure O7.
2) Tighten the bolt, first with your fingers and then
with a wrench or other appropriate tool.
3) Release the storage poles and mount them using
the ball and socket provided; secure with the pin.
4) Unzip canvas boot, if necessary.
5) Extend storage poles to reduce tension on the top.
Owner's Manual Page