Table of Contents
Advertisement
NOTE
1.
In case of the Pulley Motor installation, check if the
value of the Fig. 3-3-B is correct.
2.
When installing the Loading Motor PCB Ass'y, install it
correctly as Fig. 3-3-C.
3.
In case of the Loading Motor PCB Ass'y installation,
hook the wire on the Main Frame Ass'y as shown Fig.
3-3-C.
Pulley Motor
Loading Motor
Safety surface for pressing
of the insert.
Rack Loading
Check Hook
Loading Motor PCB Ass'y
3-4: RACK LOADING/MAIN GEAR/PULLEY GEAR
(Refer to Fig. 3-4-A)
Press down the catcher 1 and slide the Rack Loading.
1.
Unlock the support 2 and remove the Pulley Gear.
2.
3.
Remove the Main Gear.
Pulley Gear
Main Gear
2
1
NOTE
1. In case of the Rack Loading installation, do not mesh it
to the Main Gear as shown the Fig. 3-4-B.
Rack Loading
Main Gear
DISASSEMBLY INSTRUCTIONS
7.0 ± 0.1mm
Fig. 3-3-B
The Lever should be position
between A and B.
A
B
Fig. 3-3-C
Rack Loading
Main Frame Ass'y
Fig. 3-4-A
Check Hook
Fig. 3-4-B
3-5: CLAMPER ASS'Y (Refer to Fig. 3-5-A)
1.
Press the Clamper and rotate the Clamper Plate
clockwise, then unlock the 3 supports 1.
2.
Remove the Clamper Plate, Clamper Magnet and
Clamper.
Clamper Plate
Clamper Magnet
NOTE
1. In case of the Clamper Ass'y installation, install
correctly as Fig. 3-5-B.
Clamper Plate
Clamper
3-6:
TRAVERSE HOLDER/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 3-6-A)
1.
Remove the Traverse Holder.
2.
Remove the 2 Insulator (F).
3.
Remove the Insulator (R).
Main Chassis Ass'y
Insulator (F)
Traverse Holder
NOTE
1.
In case of the Insulator (F) installation, install correctly
as Fig. 3-6-B.
2.
In case of the Insulator (R) installation, install correctly
as Fig. 3-6-C.
B3-2
Main Frame
1
1
Clamper
1
No gap
Insulator (R)
Insulator (F)
Insulator (F)
Traverse Holder
Fig. 3-5-A
Fig. 3-5-B
Fig. 3-6-A
Fig. 3-6-B
Advertisement
Table of Contents
